Federal · SAM.gov · New York

Pad-Mounted Transformer

Due Jul 29, 2026·1 day left·ElectricalView official posting ↗

Issuing agency

Department of Defense

Method

Combined Synopsis/Solicitation

Description

Provide one Pad Mounted Transformer 750 kVA, 13.2 kV /208Y/120 V. Salient Characteristics: Furnish one (1) pad mounted, dead front, radial transformer, rated: ? Capacity: 750 kVA ? Phases: 3 ?

Primary Voltage: 13,200 V (15 kV class) ?Secondary Voltage: 208Y/120 V ? Frequency: 60 Hz ? Phase: Three phase ?

Cooling :ONAN ? Fluid: Mineral oil 2. Mandatory Physical Dimensions: The following dimensions are non negotiable: ?

Height: 63?� inches (up to 64?� inches) ? Width: 65 inches ? Depth: May varies (existing is 41 inches) The Contractor shall confirm with proposal the manufacturing dimensions, either in writing or by a shop drawing, for government approval.

Mechanical and Construction Requirements: The transformer shall include: ?Stainless steel tank, cabinet and hardware (304) ? Dead front construction ?

Pentahead security hardware ? ANSI 61 Grey color to match with existing enclosure ? Welded tank construction, sealed and pressure tested ?

1-inch Oil drain valve located on the primary side with 3/8-inch water sampler (required due to secondary side cable congestion) ? Arc-flash and safety labeling ? Lifting lugs and jacking pads ?

Nameplate per ANSI C57.12.00 4.Electrical Requirements: ? Primary bushings: (6) 200 A load break wells with inserts for (3)LV and (3) 10KV arresters ? Secondary bushings: NEMA spade w/ supports terminals 10holes (3) LV and (1) neutral per ANSI ?

Configuration: Radial Feed ? Impedance: Standard ANSI values for 750 kVA ? Taps: �2 x 2.5% (standard 5 position no load tap changer) 5.Protection and Monitoring: The transformer shall include: ?

Bayonet fuse with isolation link? Current limiting fuses ? Load break switch (2 position minimum) ?

Nitrogen pressure gauge, test port and blanket ? Temperature gauge ? Pressure vacuum gauge ?

Liquid level indicator ? Schrader valve Note: All gauges must be visible. 6.

Compliance Requirements: The transformer must comply with: ? ANSI/IEEE C57.12 series ? DOE 2016 efficiency standards ?

National Electrical Safety Code (NESC) ? National Electrical Code (NEC /NFPA 70) ? UFGS 26 12 19 ?

Pad Mounted, Liquid Filled, Medium Voltage Transformers ?American Buy Act ? PCB-free oil certification ? UL Listed 002.

Provide Factory routine test Reports Results and documentation as minimum: ? Insulation resistance test ? Winding resistance test ?

Turns ratio (TTR) ?Polarity and phase-relation test ? No-load and load-loss test ? Dielectric test ?

Excitation test ?Impedance test ? Applied and Induced potential tests ? Leak Test ?

Oil quality test (dielectric strength, moisture, interfacial tension) ? Certified As-built drawings ? Certified test report signed by manufacturer ?

Installation and OM manuals ? Warranty documentation (minimum 1 year) ? Destination to the federal facility Fort Buchanan, Puerto Rico00934 ?

ECD: 40 weeks ? Unit must arrive fully assembled and ready for installation ?Packing slip must include contract number, PO number, and serial number? Minimum 1 year manufacturer warranty covering defects in equipment.

Documents4

oppMgmtLink.xhtmlXHTML

Open

index.xhtmlXHTML

Open

PIEE_Solicitation_Module_Vendor_Access_Instructions.pdfPDF

Preview Download

Document 4Link

Open

Contact

Name

Diana Ruiz

diana.m.ruiz4.civ@army.mil

Address

NY 00934

Full source recordfrom SAM.gov

Type

Combined Synopsis/Solicitation

Title

Pad-Mounted Transformer

Active

Yes

Ui Link

https://sam.gov/opp/6d4854cba1ee4d9b97f4c3b948aee2ca/view

Base Type

Combined Synopsis/Solicitation

Notice Id

6d4854cba1ee4d9b97f4c3b948aee2ca

Naics Code

335311

Department

DEPARTMENT OF DEFENSE

Posted Date

Jul 22, 2026

Office Address

State: NY
Zipcode: 13602-5220
Country Code: USA

Resource Links

https://piee.eb.mil/sol/xhtml/unauth/search/oppMgmtLink.xhtml?noticeId=W911S226U3773&noticeType=CombinedSynopsisSolicitation, https://pieetraining.eb.mil/wbt/xhtml/wbt/sol/index.xhtml, https://www.acq.osd.mil/asda/dpc/ce/cap/docs/piee/PIEE_Solicitation_Module_Vendor_Access_Instructions.pdf, https://dodprocurementtoolbox.com/

Point Of Contact

Type: primary
Email: diana.m.ruiz4.civ@army.mil
Full Name: Diana Ruiz

Description Text

Provide one Pad Mounted Transformer 750 kVA, 13.2 kV /208Y/120 V. Salient Characteristics: Furnish one (1) pad mounted, dead front, radial transformer, rated: ? Capacity: 750 kVA ? Phases: 3 ? Primary Voltage: 13,200 V (15 kV class) ?Secondary Voltage: 208Y/120 V ? Frequency: 60 Hz ? Phase: Three phase ? Cooling :ONAN ? Fluid: Mineral oil 2. Mandatory Physical Dimensions: The following dimensions are non negotiable: ? Height: 63?� inches (up to 64?� inches) ? Width: 65 inches ? Depth: May varies (existing is 41 inches) The Contractor shall confirm with proposal the manufacturing dimensions, either in writing or by a shop drawing, for government approval. 3. Mechanical and Construction Requirements: The transformer shall include: ?Stainless steel tank, cabinet and hardware (304) ? Dead front construction ? Pentahead security hardware ? ANSI 61 Grey color to match with existing enclosure ? Welded tank construction, sealed and pressure tested ? 1-inch Oil drain valve located on the primary side with 3/8-inch water sampler (required due to secondary side cable congestion) ? Arc-flash and safety labeling ? Lifting lugs and jacking pads ? Nameplate per ANSI C57.12.00 4.Electrical Requirements: ? Primary bushings: (6) 200 A load break wells with inserts for (3)LV and (3) 10KV arresters ? Secondary bushings: NEMA spade w/ supports terminals 10holes (3) LV and (1) neutral per ANSI ? Configuration: Radial Feed ? Impedance: Standard ANSI values for 750 kVA ? Taps: �2 x 2.5% (standard 5 position no load tap changer) 5.Protection and Monitoring: The transformer shall include: ? Bayonet fuse with isolation link? Current limiting fuses ? Load break switch (2 position minimum) ? Nitrogen pressure gauge, test port and blanket ? Temperature gauge ? Pressure vacuum gauge ? Liquid level indicator ? Schrader valve Note: All gauges must be visible. 6. Compliance Requirements: The transformer must comply with: ? ANSI/IEEE C57.12 series ? DOE 2016 efficiency standards ? National Electrical Safety Code (NESC) ? National Electrical Code (NEC /NFPA 70) ? UFGS 26 12 19 ? Pad Mounted, Liquid Filled, Medium Voltage Transformers ?American Buy Act ? PCB-free oil certification ? UL Listed 002. Provide Factory routine test Reports Results and documentation as minimum: ? Insulation resistance test ? Winding resistance test ? Turns ratio (TTR) ?Polarity and phase-relation test ? No-load and load-loss test ? Dielectric test ? Excitation test ?Impedance test ? Applied and Induced potential tests ? Leak Test ? Oil quality test (dielectric strength, moisture, interfacial tension) ? Certified As-built drawings ? Certified test report signed by manufacturer ? Installation and OM manuals ? Warranty documentation (minimum 1 year) ? Destination to the federal facility Fort Buchanan, Puerto Rico00934 ? ECD: 40 weeks ? Unit must arrive fully assembled and ready for installation ?Packing slip must include contract number, PO number, and serial number? Minimum 1 year manufacturer warranty covering defects in equipment.

Response Dead Line

Jul 29, 2026

Full Parent Path Name

DEPARTMENT OF DEFENSE.DEPARTMENT OF THE ARMY.AMC.ACC.MISSION & INSTALLATION CONTRACTING COMMAND.419TH CSB.W6QM MICC-FT DRUM

Place Of Performance

Zip: 00934
Street Address: Fort Buchanan, Puerto Rico

Solicitation Number

W911S226U3773

Source: SAM.gov (notice 6d4854cba1ee4d9b97f4c3b948aee2ca), retrieved via the SAM.gov Get Opportunities API. View the official posting — always confirm requirements and deadlines with the issuing agency.

Not the right RFP for you?

Here are some similar opportunities

Government · Washington, DCGenerator Load Bank Testing ServicesWashington Metropolitan Area Transit Authority (WMATA) · 3d left Government · Washington, DCSMALL UNITS KIT "C" & BODY "B"Washington Metropolitan Area Transit Authority (WMATA) · 8d left Government · IndianaRFB-14DPW-1818 — LD-15-036 Eagle Creek Dam Emergency Generator ReplacementDept of Public Works · 1d left Government · Los Angeles, CAMobile Booking LiveScan System (MBLS) SolutionSheriff · 9d left

Let our AI help you find the right opportunity

Search with AI →